Coilover Care

Been trying to think of a few ways to ensure my Ohlins don’t rust for whatever reason. Getting dirty is impossible to avoid, but there are a few things I’ve been using to spray to prevent rust – namely, Boeshield T9. I basically sprayed and wiped everything down with WD40, let it dry, and hit…

JDM Rear Bumper, Taillights, and Exhaust

These are some of the first few mods I did for the Evo. JDM rear bumper, STM rear crash beam, JDM taillights (only recently found out they’re Evo 8 taillights and not Evo 9 taillights), and a Buschur SCCA legal exhaust with mil.spec high flow cat that would fit the JDM rear bumper.

Buschur Racing Harness Bar & Schroth Harness

Another carry over from my old Evo, the Buschur Racing harness bar & Schroth harnesses. While I was looking for solutions to stiffen the Evo chassis, one thing that came up was a removable harness bar – as the inside of the chassis itself is the weakest, so a harness bar helps some there, while…

Ohlins & Corner Balance

On my old Evo, my suspension set up mainly consisted of GTWorx springs & Bilstein HDs. This setup, while good, was just too soft for autox. In general that car was overpowered and undersuspended. I decided to go the opposite route with this Evo, adding more suspension than power. Went with Ohlins with the stock…